Canon IPF8400S - Cannot Feed Paper; Cannot Cut this Paper; End of Paper Feed; Rel Lever Is in Wrong Position

Cannot feed paper.
Cannot feed paper.
Cause Corrective Action
Paper could not be
advanced correctly
during feeding.
1. Lift the Release Lever and remove the jammed paper.
(See "Clearing Jammed Roll Paper.") ➔ P.853
(See "Clearing a Jammed Sheet.") ➔ P.856
2. Load paper.
3. Lower the Release Lever.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK
button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.") ➔ P.471
(See "Loading Sheets in the Printer.") ➔ P.492
Cannot cut this paper.
Cannot cut this paper.
Cause Corrective Action
There are sheets left on the
Ejection Guide.
1. Lift the Release Lever and remove the paper.
2. Load paper.
3. Lower the Release Lever.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.") ➔ P.471
There is a foreign object by
the Output Tray, obstructing
the Cutter Unit.
1. Lift the Top Cover and remove the foreign object.
2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
You are not using the printer
under the recommended envi-
ronmental conditions for the
paper.
Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions, see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.") ➔ P.462
You are using paper that is
not compatible with automatic
cutting.
1. Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.") ➔ P.483
For information about paper that is compatible with automatic cutting, see the Paper Reference
Guide.
(See "Displaying the Paper Reference Guide.") ➔ P.462
2.
Lift the Release Lever and remove the paper.
In other cases, the Cutter Unit
may be damaged.
Contact your Canon dealer for assistance.
End of paper feed.
End of paper feed.
Cause Corrective Action
Although an attempt was made to advance the paper manually, it reached the limit posi-
tion that can be advanced.
Canceling manual advancing.
(See "Feeding Roll Paper Manually.") ➔ P.481
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit. Canceling manual advancing.
Rel lever is in wrong position.
Rel lever is in wrong position.
Cause Corrective Action
The Release Lever is up. Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Cannot feed paper.
iPF8400S
User's Guide
Error Message Messages regarding paper
890