Related Commands
DescriptionCommand
Adds an automatic protection switching (APS) group and enter APS
group configuration mode.
aps group (global), on page 842
Overrides a manual or forced APS request at the local end of the SONET
link and block the protect channel from receiving traffic.
lockout, on page 870
Enables automatic switchover from the protect interface to the working
interface after the working interface becomes available.
revert, on page 890
Configures the K1K2 overhead byte signaling protocol used for APS.signalling, on page 918
Displays the operational status for all configured SONET APS groups.show aps, on page 893
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
841
SONET Controller Commands on the Cisco ASR 9000 Series Router
aps group
To Next Page
Loading...
Need help?
General
