xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
998
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Ping Statistics for 3FFE:2::D04D:7878:66D:E5BC
Packets: Sent =10, Received =10, Lost =0
29-18 traceroute
Description
This command is used to trace a route between the switch and a given host on the network.
Format
traceroute [<ipaddr> | <domain_name 255>] {ttl <value 1-60> | port <value 30000-64900> |
timeout <sec 1-65535> | probe <value 1-9>}
Parameters
<ipaddr> - Specify the IP address of the destination end station.
<domain_name 255> - Specify the domain name of the destination end station.
ttl - (Optional) Specify the time to live value of the trace route request.
<value 1-60> - Specify the time to live value of the trace route request. This is the maximum
number of routers that a trace route packet can pass while seeking the network path between
two devices. The range for the TTL is 1 to 60 hops. The default value is 30.
port - (Optional) Specify the port number.
<value 30000-649000> - Specify the port number. The value range is from 30000 to 64900. The
timeout - (Optional) Specify the timeout period while waiting for a response from the remote device.
<sec 1-65535> - Specify the timeout period while waiting for a response from the remote device.
A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
probe – (Optional) Specify the number of probes.
<value 1-9> - Specify the number of probes. The range is from 1 to 9. If unspecified, the default
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To trace the route path between the switch and 10.48.74.121:
DGS-3420-28SC:admin#traceroute 10.48.74.121 probe 3
Command: traceroute 10.48.74.121 probe 3
To Next Page
Loading...
