D-Link xStack DGS-3420 Series - Page 1004

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
999
<10 ms 10.12.73.254
<10 ms 10.12.73.254
<10 ms 10.19.68.1
<10 ms 10.19.68.1
<10 ms 10.19.68.1
<10 ms 10.48.74.121
Trace complete.
DGS-3420-28SC:admin#
29-19 traceroute6
Description
This command is used to trace the IPv6 routed path between the Switch and a destination end station.
Format
traceroute6 [<ipv6addr> | <domain_name 255>] {ttl <value 1-60> | port <value 30000-64900> |
timeout <sec 1-65535> | probe <value 1-9>}
Parameters
<ipv6addr> - Enter the IPv6 address of the destination end station here.
<domain_name 255> - Enter the domain name of the destination end station here. This name can
be up to 255 characters long.
ttl - (Optional) Specify the time to live value of the trace route request.
<value 1-60> - Specify the time to live value of the trace route request. This is the maximum
number of routers that a trace route packet can pass while seeking the network path between
two devices. The range for the TTL is 1 to 60 hops. The default value is 30.
port - (Optional) Specify the port number.
<value 30000-649000> - Specify the port number. The value range is from 30000 to 64900. The
default is 33435.
timeout - (Optional) Specify the timeout period while waiting for a response from the remote device.
<sec 1-65535> - Specify the timeout period while waiting for a response from the remote device.
A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
probe – (Optional) Specify the number of probes.
<value 1-9> - Specify the number of probes. The range is from 1 to 9. If unspecified, the default
value is 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
Trace the IPv6 routed path between the switch and 3000::1:
DGS-3420-28SC:admin# traceroute6 3000::1
Command: traceroute6 3000::1