D-Link xStack DGS-3420 Series - Page 1006

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1001
DGS-3420-28SC:admin#telnet 10.1.1.1
Command: telnet 10.1.1.1
DGS-3420-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.50.010
Copyright(C) 2011 D-Link Corporation. All rights reserved.
UserName:
29-21 config telnet source_ipif
Description
This command is used to select an address of an interface as the source address for TELNET client.
Format
config telnet source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters long.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to remove the specified source address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IP 10.90.90.90 on the System interface as the source address:
DGS-3420-28SC:admin#config telnet source_ipif System 10.90.90.90
Command: config telnet source_ipif System 10.90.90.90
Success.
DGS-3420-28SC:admin#
29-22 show telnet source_ipif
Description
This command is used to show the configured source address for TELNET client.