D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1042
Format
disable vlan_trunk
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable VLAN trunking:
DGS-3420-28SC:admin#disable vlan_trunk
Command: disable vlan_trunk
Success.
DGS-3420-28SC:admin#
33-3 config vlan_trunk ports
Description
This command is used to configure a port as a VLAN trunking port. By default, none of the ports is a
VLAN trunking port. A VLAN trunking port and a non-VLAN trunking port cannot be grouped as an
aggregated link. To change the VLAN trunking setting for an aggregated link, the user must apply the
command to the master port. If the command is applied to link aggregation member port excluding the
master, the command will be rejected. Ports with different VLAN configurations are not allowed to form
an aggregated link. However, if they are specified as a VLAN trunking port, they are allowed to form
an aggregated link.
For a VLAN trunking port, the VLANs on which the packets can be by passed will not be advertised by
GVRP on this port. However, since the traffic on these VLANs is forwarded, this VLAN trunking port
should participate in the MSTP instances corresponding to these VLANs.
Format
config vlan_trunk ports [<portlist> | all] | state [enable | disable]
Parameters
ports - Specify the ports to be configured.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English