xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1043
<portlist> - Specify the list of ports to be configured.
all - Specify all ports will be configured.
state - Specify the ports as VLAN or non-VLAN trunking ports.
enable - Specify the ports as VLAN trunking ports.
disable - Specify the ports as non-VLAN trunking ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure ports 1 to 5 as VLAN trunking ports:
DGS-3420-28SC:admin#config vlan_trunk ports 1-5 state enable
Command: config vlan_trunk ports 1-5 state enable
Success.
To configure port 6 as an LA-1 member port and port 7 as an LA-2 master port:
DGS-3420-28SC:admin# config vlan_trunk ports 6-7 state enable
Command: config vlan_trunk ports 6-7 state enable
Warning: Port 6 is a Link Aggregation member port, VLAN trunk is not enabled on
port 6.
Success.
DGS-3420-28SC:admin# config vlan_trunk ports 7 state disable
Command: config vlan_trunk ports 7 state disable
Success.
DGS-3420-28SC:admin# config vlan_trunk ports 6-7 state disable
Command: config vlan_trunk ports 6-7 state disable
Warning: Port 6 is a Link Aggregation member port, VLAN trunk is not enabled on
port 6.
Success.
To configure port 6 as an LA-1 member port and port 7 as an LA-1 master port:
DGS-3420-28SC:admin# config vlan_trunk ports 6-7 state enable
Command: config vlan_trunk ports 6-7 state enable
To Next Page
Loading...
