D-Link xStack DGS-3420 Series - Page 1101

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1096
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Can be "inward" or "outward".
mepid: Represents the MEPID of the MEP.
macaddr: Represents the MAC address of the MEP.
Event description: Error CFM CCM packet is detected
Log Message: MD Level:<mdlevel>, VLAN:<vlanid>, Local(Port
<[unitID:]portNum>, Direction:<mepdirection>)
Remote(MEPID:<mepid>, MAC:<macaddr>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Can be "inward" or "outward".
mepid: Represents the MEPID of the MEP.
macaddr: Represents the MAC address of the MEP.
Warning
Event description: Cannot receive the remote MEP's CCM packet
Log Message: CFM remote down. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection:
Represents the MEP direction, which can be "inward" or
"outward"..
Warning
Event description: Remote MEP's MAC reports an error status
Log Message: CFM remote MAC error. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection:
Represents the MEP direction, which can be "inward" or
"outward".
Warning
Event description: Remote MEP detects CFM defects
Log Message: CFM remote detects a defect. MD Level:<mdlevel>,
VLAN:<vlanid>, Local(Port <[unitID:]portNum>,
Direction:<mepdirection>)
Parameters description:
vlanid: Represents the VLAN identifier of the MEP.
mdlevel: Represents the MD level of the MEP.
Informational