D-Link xStack DGS-3420 Series - Page 1103

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1098
unitID: Represents the ID of the device in the stacking system.
portNum: Represents the logical port number of the MEP.
mepdirection: Represents the direction of the MEP. This can be
"inward" or "outward".
mepid: Represents the MEPID of the MEP.
DDM
Event description: DDM exceeded or recover from DDM alarm
threshold
Log Message: DDM Port <[unitID:]portNum> optic module
[thresholdType] [exceedType] the [thresholdSubType] alarm threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of
the following values: temperature, supply voltage, bias current, TX
power, RX power.
exceedType: indicate exceed threshold or recover to normal event,
the value should be “recovered from” or “exceeded”
thesholdSubType: the DDM threshold sub type, the value should be
“high” or “low”.
Critical
Event description: DDM exceeded or recover from DDM warning
threshold
Log Message: DDM Port <[unitID:]portNum> optic module
[thresholdType] [exceedType] the [thresholdSubType] warning
threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of
the following values: temperature, supply voltage, bias current, TX
power, RX power.
exceedType: indicate exceed threshold or recover to normal event,
the value should be “recovered from” or “exceeded”
thesholdSubType: the DDM threshold sub type, the value should be
“high” or “low”.
Warning
IP and
Password
Event description: Password change activity
Log Message: Unit <unitID>, Password was changed by [console]
(Username: <username>[, IP: <ipaddr>])
Parameters description:
unitID: Represents the unit ID
username: Represents user name.
ipaddr: Represents IP address.
Informational The string “[console]”
is just for console
session.
The string "[, IP:
<ipaddr>]" is not for
console session.
Event description: System IP address change activity
Log Message: Unit <unitID>, Management IP address was changed
by [console] (Username: <username>[, IP: <ipaddr>])
Parameters description:
unitID: Represents the unit ID
username: Represents user name.
Informational The string “[console]”
is just for console
session.
The string "[, IP:
<ipaddr>]" is not for
console session.