D-Link xStack DGS-3420 Series - Page 215

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
210
Parameters
None.
Restrictions
None.
Example
To display the configuration of the all-MPs-reply-to-LTR function:
DGS-3420-28SC:admin#show cfm mp_ltr_all
Command: show cfm mp_ltr_all
All MPs reply LTRs: Disabled
DGS-3420-28SC:admin#
14-25 show cfm pkt_cnt
Description
This command is used to display the CFM packet’s RX/TX counters.
Format
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) Specify the port counters to display. If not specified, all ports will be displayed.
<portlist> - Specify a list of ports.
rx - (Optional) Display the RX counter. If not specified, both the RX and TX counters will be
displayed.
tx - (Optional) Display the TX counter. If not specified, both the RX and TX counters will be
displayed.
rx - (Optional) Display the RX counter. If not specified, both the RX and TX counters will be
displayed.
tx - (Optional) Display the TX counter. If not specified, both the RX and TX counters will be
displayed.
ccm - (Optional) Display the CCM RX counters.
Restrictions
None.
Example
To display CFM packet RX/TX counters for ports 1 to 2: