D-Link xStack DGS-3420 Series - Page 262

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
257
19-17 debug dhcpv6_client output
Description
Used to set debug message to output to buffer or console.
Format
debug dhcpv6_client output [buffer | console]
Parameters
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to console:
DGS-3420-28SC:admin# debug dhcpv6_client output console
Command: debug dhcpv6_client output console
Success.
DGS-3420-28SC:admin#
19-18 debug dhcpv6_client packet
Description
Used to enable or disable debug information flag for DHCPv6 client packet, including packet receiving
and sending.
Format
debug dhcpv6_client packet {all | receiving | sending} state [enable | disable]
Parameters
all - (Optional) Set packet receiving and sending debug flags.
receiving - (Optional) Set packet receiving debug flag.
sending - (Optional) Set packet sending debug flag.
state - Specifies that the designated flags will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.