D-Link xStack DGS-3420 Series - Page 266

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
261
Format
debug dhcpv6_relay packet {all | receiving | sending} state [enable | disable]
Parameters
all - (Optional) Set packet receiving and sending debug flags.
receiving - (Optional) Set packet receiving debug flag.
sending - (Optional) Set packet sending debug flag.
state - Specifies if the designated flags function will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled DHCPv6 relay packet sending debug:
DGS-3420-28SC:admin# debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
DGS-3420-28SC:admin#
19-24 debug dhcpv6_server packet
Description
This command is used to enable or disable the debug information flag of the DHCPv6 server packet,
including packets receiving and sending.
Format
debug dhcpv6_server packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specifies the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.