D-Link xStack DGS-3420 Series - Page 265

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
260
Example
To enable debug information flag about the hop count:
DGS-3420-28SC:admin# debug dhcpv6_relay hop_count state enable
Command: debug dhcpv6_relay hop_count state enable
Success.
DGS-3420-28SC:admin#
19-22 debug dhcpv6_relay output
Description
Used to set debug message to output to buffer or console.
Format
debug dhcpv6_relay output [buffer | console]
Parameters
output - Specifies the location of the debug message output.
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to console:
DGS-3420-28SC:admin# debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
DGS-3420-28SC:admin#
19-23 debug dhcpv6_relay packet
Description
Used to enable or disable debug information flag for DHCPv6 relay packet, including packet receiving
and sending.