D-Link xStack DGS-3420 Series - Page 264

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
259
19-20 debug dhcpv6_relay state disable
Description
This command is used to disable the DHCPv6 relay Debug function.
Format
debug dhcpv6_relay state disable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disabled DHCPv6 relay debug function:
DGS-3420-28SC:admin# debug dhcpv6_relay state disable
Command: debug dhcpv6_relay state disable
Success.
DGS-3420-28SC:admin#
19-21 debug dhcpv6_relay hop_count state
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
state - Specifies the hop count debugging state.
enable - Specifies that the hop count state will be enabled.
disable - Specifies that the hop count state will be disabled.
Restrictions
Only Administrator-level users can issue this command.