D-Link xStack DGS-3420 Series - Page 270

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
265
DGS-3420-28SC:admin# debug ripng show flag
Command: debug ripng show flag
Current Enabled RIPng Flags:
Interface State Change
Packet Receiving
Packet Sending
Route
DGS-3420-28SC:admin#
19-29 debug ripng state disable
Description
This command is used to disable the RIPng debugging state.
Format
debug ripng state disable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable RIPng debug globally:
DGS-3420-28SC:admin# debug ripng state disable
Command: debug ripng state disable
Success.
DGS-3420-28SC:admin#
19-30 debug ripng state enable
Description
This command is used to enable the RIPng debugging state.