D-Link xStack DGS-3420 Series

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
269
all - Specifies that all the box IDs will be used.
sio1 - Specifies that the first stacking port will be used.
sio2 - Specifies that the second stacking port will be used.
Restrictions
Only Administrator-level users can issue this command.
Example
To show error statistics information of the SIO port:
DGS-3420-28SC:admin#debug show error ports box_id all sio1
Command: debug show error ports box_id all sio1
Box ID 1 SIO 1:
RX Frames TX Frames
--------- ---------
CRC Error 0 Excessive Deferral 0
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 0 Excessive Collision 0
Jabber 0 Single Collision 0
Buffer Full Drop 0 Collision 0
Symbol Error 0 STP Drop 0
Multicast Drop 0 HOL DROP 0
VLAN Ingress Drop 0 COS0 HOL DROP 0
STP Drop 0 COS1 HOL DROP 0
MTU Drop 0 COS2 HOL DROP 0
COS3 HOL DROP 0
COS4 HOL DROP 0
COS5 HOL DROP 0
COS6 HOL DROP 0
COS7 HOL DROP 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
19-34 debug show jwac auth_info
Description
This command is used to show debug information of JWAC.
Format
debug show jwac auth_info