xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
308
Example
To configure the NetBIOS node type:
DGS-3420-28SC:admin#config dhcp pool netbios_node_type knicks hybrid
Command: config dhcp pool netbios_node_type knicks hybrid
Success.
22-11 config dhcp pool default_router
Description
This command is used to specify the IP address of the default router for a DHCP client. Up to three IP
addresses can be specified on one command line.
After a DHCP client has booted, the client begins sending packets to its default router. The IP address
of the default router should be on the same subnet as the client. If the default router is not specified,
the default router information will not be provided to the client. If this command is input twice for the
same pool, the second command will overwrite the first command. The default router must be within
the range the network defined for the DHCP pool.
Format
config dhcp poo
l default_ro
uter <pool_
name 12> {<ipaddr
> {<ipaddr> {<
ipaddr>}}}
Parameters
<pool_name 12> - Specify the DHCP pool name.
<ipaddr> - (Optional) Specify the IP address of the default router. Up to three IP addresses can be
specified on one command line.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the default router:
DGS-3420-28SC:admin#config dhcp pool default_router nyknicks 10.10.10.1
Command: config dhcp pool default_router nyknicks 10.10.10.1
Success.
To Next Page
Loading...
Need help?
General