D-Link xStack DGS-3420 Series - Page 312

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
307
Parameters
<pool_name 12> - Specify the DHCP pool name.
<ipaddr> - (Optional) Specify the IP address of the WINS server. Up to three IP addresses can be
specified on one command line.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a WINS server IP address:
DGS-3420-28SC:admin#config dhcp pool netbios_name_server knicks 10.10.10.1
Command: config dhcp pool netbios_name_server knicks 10.10.10.1
Success.
DGS-3420-28SC:admin#
22-10 config dhcp pool netbios_node_type
Description
This command is used to specify the NetBIOS node type for a Microsoft DHCP client.
The NetBIOS node type for Microsoft DHCP clients can be one of four settings: broadcast, peer-to-
peer, mixed, or hybrid. Use this command to configure a NetBIOS over TCP/IP device that is
described in RFC 1001/1002. By default, the NetBIOS node type is broadcast.
Format
config dhcp pool netbios_node_type <pool_name 12> [broadcast | peer_to_peer | mixed |
hybrid]
Parameters
<pool_name 12> - Specify the DHCP pool name.
broadcast - Specify the NetBIOS node type for Microsoft DHCP clients as broadcast.
peer_to_peer - Specify the NetBIOS node type for Microsoft DHCP clients as peer_to_peer.
mixed - Specify the NetBIOS node type for Microsoft DHCP clients as mixed.
hybrid - Specify the NetBIOS node type for Microsoft DHCP clients as hybrid.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.