D-Link xStack DGS-3420 Series - Page 340

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
335
Example
To enable the trap for a DHCP server filter event:
DGS-3420-28SC:admin#config filter dhcp_server trap enable
Command: config filter dhcp_server trap enable
Success.
DGS-3420-28SC:admin#
23-4 show filter dhcp_server
Description
This command is used to display the DHCP server/client filter list created on the switch.
Format
show filter dhcp_server
Parameters
None.
Restrictions
None.
Example
To display the DHCP server/client filter list created on the switch:
DGS-3420-28SC:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports: 1,28
Trap State: Enabled
Log State: Enabled
Illegal Server Log Suppress Duration:1 minutes
Permit DHCP Server/Client Table:
Server IP Address Client MAC Address Port
----------------- ------------------ --------------------
Total Entries: 0
DGS-3420-28SC:admin#