D-Link xStack DGS-3420 Series - Page 341

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
336
23-5 create filter dhcpv6_server permit sip
Description
This command used to create a permit entry. The specific DHCPv6 server packets, with the source
IPv6 address, will be forwarded on the specified port(s).
Format
create filter dhcpv6_server permit sip <ipv6addr> ports [<portlist> | all]
Parameters
<ipv6addr> - Specifies the source address of the entry which will be created into the Filter
DHCPv6 server forward list.
ports - Specifies the list of ports used for this configuration.
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all ports will be used for this configuration.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a Filter DHCPv6 server permit entry on port 5:
DGS-3420-28SC:admin#create filter dhcpv6_server permit sip 2200::5 ports 1:5
Command: create filter dhcpv6_server permit sip 2200::5 ports 1:5
Success.
DGS-3420-28SC:admin#
23-6 config filter dhcpv6_server log
Description
This command is used to enable or disable the Filter DHCPv6 server log state.
Format
config filter dhcpv6_server log [enable | disable]
Parameters
enable - Specifies that the log for the Filter DHCPv6 server will be enabled. The log for Filter
DHCPv6 server will be generated.