D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
337
disable - Specifies that the log for the Filter DHCPv6 server will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the Filter DHCPv6 Server log state:
DGS-3420-28SC:admin#config filter dhcpv6_server log enable
Command: config filter dhcpv6_server log enable
Success.
DGS-3420-28SC:admin#
23-7 config filter dhcpv6_server ports
Description
This command is used to configure the state of filter DHCPv6 server packets on the switch. The filter
DHCPv6 server function is used to filter the DHCPv6 server packets on the specific port(s) and receive
the trust packets from the specific source. This feature can be protected network usable when a
malicious host sends the DHCPv6 server packets.
Format
config filter dhcpv6_server ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all ports will be used for this configuration.
state - Specifies whether the port’s filter DHCPv6 server function is enabled or disabled.
enable - Specifies that the filter option is enabled.
disable - Specifies that the filter option is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the filter DHCPv6 server state to enabled for ports 1 to 8:
DGS-3420-28SC:admin#config filter dhcpv6_server ports 1:1-1:8 state enable
Command: config filter dhcpv6_server ports 1:1-1:8 state enable

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English