xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
338
23-8 config filter dhcpv6_server trap
Description
This command is used to enable or disable the filter DHCPv6 server trap state.
Format
config filter dhcpv6_server trap [enable | disable]
Parameters
enable - Specifies that the trap for the filter DHCPv6 server will be enabled. The trap for filter
DHCPv6 server will be sent out.
disable - Specifies that the trap for the filter DHCPv6 server will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the filter DHCPv6 server trap state:
DGS-3420-28SC:admin#config filter dhcpv6_server trap enable
Command: config filter dhcpv6_server trap enable
Success.
23-9 show filter dhcpv6_server
Description
This command is used to display the filter DHCPv6 server information.
Format
show filter dhcpv6_server
Parameters
None.
To Next Page
Loading...
