D-Link xStack DGS-3420 Series - Page 345

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
340
Success.
DGS-3420-28SC:admin#
23-11 create filter icmpv6_ra_all_node permit sip
Description
This command is used to create a filter ICMPv6 RA All-nodes permit entry.
Format
create filter icmpv6_ra_all_node permit sip <ipv6addr> ports [<portlist> | all]
Parameters
<ipv6addr> - Enter the source address of entry which will be created into the Filter ICMPv6 RA
All-nodes forward list here.
state - Specifies whether the port’s filter DHCPv6 server function is enabled or disabled.
enable - Specifies that the filter option is enabled.
disable - Specifies that the filter option is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a filter ICMPv6 RA All-nodes permit entry on port 5:
DGS-3420-28SC:admin#create filter icmpv6_ra_all_node permit sip 2200::5 ports 1:5
Command: create filter icmpv6_ra_all_node permit sip 2200::5 ports 1:5
Success.
DGS-3420-28SC:admin#
23-12 config filter icmpv6_ra_all_node log
Description
This command is used to enable or disable the filter ICMPv6 RA All-nodes log state.
Format
config filter icmpv6_ra_all_node log [enable | disable]