xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
342
Example
To configure the filter ICMPv6 RA all-nodes state to enabled for ports 1 to 8:
DGS-3420-28SC:admin#config filter icmpv6_ra_all_node ports 1:1-1:8 state enable
Command: config filter icmpv6_ra_all_node ports 1:1-1:8 state enable
Success.
23-14 config filter icmpv6_ra_all_node trap
Description
This command is used to enable or disable the filter ICMPv6 RA all-nodes trap state. If the ICMPv6
RA all-nodes server trap state is disabled, no trap will be sent out.
Format
config filter icmpv6_ra_all_node trap [enable | disable]
Parameters
enable - Specifies that the trap for the filter ICMPv6 RA all-nodes will be enabled. The trap for
filter ICMPv6 RA all-nodes will be sent out.
disable - Specifies that the trap for the filter ICMPv6 RA all-nodes will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes trap state:
DGS-3420-28SC:admin#config filter icmpv6_ra_all_node trap enable
Command: config filter icmpv6_ra_all_node trap enable
Success.
23-15 show filter icmpv6_ra_all_node
Description
This command is used to display the filter ICMPv6 RA all-nodes information.
To Next Page
Loading...
