D-Link xStack DGS-3420 Series - Page 408

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
403
Success.
DGS-3420-28SC:admin#
32-6 config erps log
Description
This command is used to configure the ERPS log state.
Format
config erps log [enable | disable]
Parameters
enable - Enable the log state. The default value is disabled.
disable - Disable the log state.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the log state:
DGS-3420-28SC:admin#config erps log enable
Command: config erps log enable
Success.
DGS-3420-28SC:admin#
32-7 config erps trap
Description
This command is used to configure trap state of ERPS events.
Format
config erps trap [enable | disable]
Parameters
trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.