D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
421
Idx Info Attr Size Update Time Name
--- ------- ---- -------- -------------------- ----
1 RUN(*) -rw- 4796564 2000/01/22 03:52:03 runtime.had
2 CFG(*) -rw- 24120 2000/01/22 23:22:58 config.cfg
3 CFG(b) -rw- 24120 2000/01/23 06:59:39 1
4 d--- 2000/01/23 22:52:50 system
30608 KB total (25700 KB free)
(*) –with boot up info (b) –with backup info
DGS-3420-28SC:admin#
To list a system directory:
DGS-3420-28SC:admin#dir c:/system
Command: dir c:/system
System reserved directory. Used space 89KB.
DGS-3420-28SC:admin#
35-6 rename
Description
This command is used to rename a file in the file system. The pathname specifies the file (in path form)
to be renamed and the file name specifies the new file name. If the path name is not a full path, then it
refers to a path under the current directory for the drive. The renamed file will stay in the same
directory.
Format
rename {{unit <unit_id>} <drive_id>} <pathname> <filename>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the file (in path form) to be renamed.
<filename> - Specify the new name of the file.
Restrictions
Only Administrator and Operator-level users can issue this command.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English