D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
420
Restrictions
None.
Example
To change a work directory:
DGS-3420-28SC:admin#cd d1
Command: cd d1
Current work directory: “c:/d1”
DGS-3420-28SC:admin#
35-5 dir
Description
This command is used to list all of the files located in a directory of a drive. If a path name is not
specified, then all of the files in the specified drive will be displayed. If none of the parameters are
specified, the files in the current directory will be displayed. If a user lists the system directory, the
used space will be shown.
Format
dir {{unit <unit_id>} <drive_id>} {<pathname>}
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - (Optional) Specify the directory to be listed. The path name can be specified
either as a full path name or partial name. For a partial path name, it indicates the file is in the
current directory. The drive ID also included in this parameter, for example:
d:/config/bootup.cfg.
Restrictions
None.
Example
To list a directory:
DGS-3420-28SC:admin#dir
Command: dir
Directory of c:/

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English