D-Link xStack DGS-3420 Series - Page 428

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
423
35-8 format
Description
This command is used to format a specific drive.
Format
format {unit <unit_id>} <drive_id> {[fat16 | fat32]} {<label_name>}
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID.
fat16 - (Optional) Specifies that the drive will be formatted to support a FAT16 file system.
fat32 - (Optional) Specifies that the drive will be formatted to support a FAT32 file system.
<label_name> - (Optional) Enter the label name used for this drive here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To format media:
DGS-3420-28SC:admin#format d: fat32
Command: format d: fat32
Formatting........................... Done!
DGS-3420-28SC:admin#
35-9 del
Description
This command is used to delete a file. It is also used to delete a directory and its contents. The system
will prompt if the target file is a bootup image/configuration or the last image.
Format
del {{unit <unit_id>} <drive_id>} <pathname> {recursive}
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.