D-Link xStack DGS-3420 Series - Page 429

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
424
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the file or directory to be deleted. If it is specified in the associated form,
then it is related to the current directory.
recursive - (Optional) Used on the directory, to delete a directory and its contents even if it is not
empty.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a file:
DGS-3420-28SC:admin#del cfg
Command: del cfg
Are you sure to remove the boot up Configuration from this device? (y/n)y
Success.
DGS-3420-28SC:admin#
To delete a directory with the parameter “recursive”:
DGS-3420-28SC:admin# del d1 recursive
Command: del d1 recursive
Success.
DGS-3420-28SC:admin#
35-10 move
Description
This command is used to move a file around the file system. Note that when a file is moved, it can be
specified whether to be renamed at the same time.
Format
move {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.