D-Link xStack DGS-3420 Series - Page 430

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
425
<pathname> - Specify the file to be moved. The path name can be specified either as a full path
name or partial name. For a partial path name, it indicates the file is in the current directory.
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the new path where the file will be moved. The path name can be
specified either as a full path name or partial name. For a partial path name, it indicates the
file is in the current directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To move a file or directory:
DGS-3420-28SC:admin#move c:/log.txt c:/abc/log1.txt
Command: move c:/log.txt c:/abc/log1.txt
Success.
DGS-3420-28SC:admin#
35-11 copy
Description
This command is used to copy a file to another file in the file system.
Format
copy {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the file to be copied. If it is specified in the associated form, then it is
related to the current directory.
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Specify the file to copy to. If it is specified in the associated form, then it is related
to the current directory
Restrictions
Only Administrator and Operator-level users can issue this command.