To Next Page

To Previous Page

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide

506

44-4 config address_binding ip_mac ipaddress

Description

This command is used to update an address binding entry.

Format

config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports

[<portlist>| all ]}

Parameters

<ipaddr> - Specify the IP address.

mac_address - Specify the MAC address.

<macaddr> - Enter the MAC address here.

ports - (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all

ports.

<portlist> - Specify the list of ports to apply.

all - Specify to apply to all the ports.

Restrictions

Only Administrator, Operator and Power-User level users can issue this command.

Example

To configure an address binding entry:

DGS-3420-28SC:admin#config address_binding ip_mac ipaddress 10.1.1.1 mac_address

00-00-00-00-00-11

Command: config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-00-

00-11

Success.

DGS-3420-28SC:admin#

44-5 config address_binding ip_mac ipv6address

Description

This command is used to update an address binding entry using IPv6.

Format

config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports

[<portlist> | all]}

D-Link xStack DGS-3420 Series User Manual

Questions and Answers: