D-Link xStack DGS-3420 Series - Page 512

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
507
Parameters
ipv6address - Specifies the IPv6 address used.
<ipv6addr> - Enter the IPv6 address used here.
mac_address - Specify the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all
ports.
<portlist> - Specify the list of ports to apply.
all - Specify to apply to all the ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a static IPv6 IMPB entry so that that IPv6 address fe80::240:5ff:fe00:28 is bound to the
MAC address 00-00-00-00-00-11:
DGS-3420-28SC:admin# config address_binding ip_mac ipv6address
fe80::240:5ff:fe00:28 mac_address 00-00-00-00-00-11
Command: config address_binding ip_mac ipv6address fe80::240:5ff:fe00:28
mac_address 00-00-00-00-00-11
Success.
DGS-3420-28SC:admin#
44-6 delete address_binding blocked
Description
This command is used to delete a blocked entry. It specifies the address database that the system has
automatically learned and blocked.
Format
delete address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]
Parameters
all - Specifies that all the blocked MAC addresses will be used.
vlan_name - Specifies the name of the VLAN that the blocked MAC address belongs to.
<vlan_name> - Enter the VLAN name used here.
mac_address - Specifies the MAC address of the blocked MAC address.
<macaddr> - Enter the MAC address used here.