D-Link xStack DGS-3420 Series - Page 594

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
589
Parameters
<portlist> - (Optional) Specify the ports to be displayed.
Note: When a port list is not specified, information for all ports will be displayed.
Restrictions
None.
Example
To display LLDP TLV option port 1:
DGS-3420-28SC:admin#show lldp ports 1
Command: show lldp ports 1
Port ID : 1
--------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Disabled
Advertised TLVs Option :
Port Description Disabled
System Name Disabled
System Description Disabled
System Capabilities Disabled
Enabled Management Address
(None)
Port VLAN ID Disabled
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status Disabled
Link Aggregation Disabled
Maximum Frame Size Disabled
DGS-3420-28SC:admin#
51-9 config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities TLV
is detected for an MSAP identifier not associated with an existing LLDP remote system MIB, the