D-Link xStack DGS-3420 Series

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
590
application layer shall start the fast start mechanism and set the ‘medFastStart’ timer to
‘medFastStartRepeatCount’ times 1. The default value is 4.
Format
config lldp_med fast_start repeat_count <value 1-10>
Parameters
<value 1-10> - Specify a fast start repeat count value between 1 and 10. The default value is 4.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure a LLDP-MED fast start repeat count of 5:
DGS-3420-28SC:admin#config lldp_med fast_start repeat_count 5
Command: config lldp_med fast_start repeat_count 5
Success.
DGS-3420-28SC:admin#
51-10 config lldp_med log state
Description
This command is used to configure the log state of LLDP-MED events.
Format
config lldp_med log state [enable | disable]
Parameters
enable - Enable the log state for LLDP-MED events.
disable - Disable the log state for LLDP-MED events. The default is disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the log state of LLDP-MED events: