To Next Page

To Previous Page

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide

628

DGS-3420-28SC:admin#config mac_based_access_control max_users 2

Command: config mac_based_access_control max_users 2

Success.

DGS-3420-28SC:admin#

55-13 config mac_based_access_control authorization attributes

Description

This command is used to enable or disable the acceptance of an authorized configuration. When

authorization is enabled for MAC-based access controls with RADIUS authentication, the authorized

attributes (for example VLAN, 802.1p default priority, and ACL) assigned by the RADUIS server will be

accepted if the global authorization status is enabled. When authorization is enabled for MAC-based

access controls with local authentication, the authorized attributes assigned by the local database will

be accepted.

Format

config mac_based_access_control authorization attributes {radius [enable | disable] | local

[enable | disable]}(1)

Parameters

radius - Specify to enable or disable the authorized attributes assigned by the RADIUS server that

will be accepted.

enable - If specified to enable, the authorized attributes (for example VLAN, 802.1p default

priority, and ACL) assigned by the RADIUS server will be accepted if the global authorization

status is enabled. The default state is enabled.

disable - If specified to disable, the authorized attributes (for example VLAN, 802.1p default

priority, and ACL) assigned by the RADIUS server will not be accepted even if the global

authorization status is enabled.

local - Specify to enable or disable the authorized attributes assigned by the local database.

enable - If specified to enable, the authorized attributes assigned by the local database will be

accepted if the global authorization status is enabled. The default state is enabled.

disable - If specified to disable, the authorized attributes assigned by the local database will not

be accepted even if the global authorization status is enabled.

Restrictions

Only Administrator, Operator and Power-User level users can issue this command.

Example

To disable the configuration authorized from the local database:

DGS-3420-28SC:admin#config mac_based_access_control authorization attributes local

disable

Command: config mac_based_access_control authorization attributes local disable

D-Link xStack DGS-3420 Series User Manual

Questions and Answers: