D-Link xStack DGS-3420 Series - Page 653

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
648
Format
config mld_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all] {state [enable |
disable] | fast_done [enable | disable] | proxy_reporting {state [enable | disable] | source_ip
<ipv6addr>}(1)}(1)
Parameters
vlan_name - Specify the name of the VLAN for which MLD snooping is to be configured.
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
vlanid - Specify the VLAN ID list.
<vlanid_list> - Specify the VLAN ID list.
all - Specify to configure all VLANs.
state - Enable or disable MLD snooping for the chosen VLAN.
enable - Enable MLD snooping for the chosen VLAN.
disable - Disable MLD snooping for the chosen VLAN.
fast_done - Enable or disable the MLD snooping fast leave function. If enabled, the membership
is immediately removed when the system receive the MLD leave message.
enable - Enable the MLD snooping fast leave function.
disable - Disable the MLD snooping fast leave function.
proxy_reporting - Specifies that the proxy reporting function will be configured.
state - Specifies the state of the proxy reporting function.
enable - Specifies that the proxy reporting function will be enabled.
disable - Specifies that the proxy reporting function will be disabled.
source_ip - Specifies the source IPv6 address used.
<ipv6addr> - Enter the source IPv6 address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure MLD snooping:
DGS-3420-28SC:admin#config mld_snooping vlan_name default state enable
Command: config mld_snooping vlan_name default state enable
Success.
DGS-3420-28SC:admin#
58-2 config mld_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress MLD control packets.