D-Link xStack DGS-3420 Series - Page 654

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
649
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Specify a range of ports to be configured.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Specify the VLAN ID list.
<value 1-1000> - Specify the rate limit of MLD control packet that the switch can process on a
specific port/VLAN. The rate is specified in packet per second. The packet that exceeds the
limited rate will be dropped.
no_limit - The default setting is no limit.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD snooping packet rate limit on port 1 for 100:
DGS-3420-28SC:admin#config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-3420-28SC:admin#
58-3 show mld_snooping rate_limit
Description
This command is used to display the MLD snooping rate limit setting.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specify a range of ports to be displayed.
<portlist> - Specify a range of ports to be displayed.
vlanid - Specify a range of VLANs to be displayed.
<vlanid_list> - Specify the VLAN ID list.