D-Link xStack DGS-3420 Series - Page 687

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
682
DGS-3420-28SC:admin#show greeting_message
Command: show greeting_message
===============================================================================
DGS-3420-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.50.010
Copyright(C) 2011 D-Link Corporation. All rights reserved.
===============================================================================
DGS-3420-28SC:admin#
60-3 config command_prompt
Description
This command is used to modify the command prompt. The current command prompt consists of four
parts: “product name” + “:” + ”user level” + ”#” (e.g. “DGS-3420-28SC:admin#”). This command is
used to modify the first part (1. “product name”) with a string consisting of a maximum of 16 characters,
or to be replaced with the users’ login user name.
Format
config command_prompt [<string 16> | username | default]
Parameters
<string 16> - Specify the new command prompt string of no more than 16 characters.
username - Specify the command to set the login username as the command prompt.