D-Link xStack DGS-3420 Series - Page 731

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
726
Format
show syslog source_ipif
Parameters
None.
Restrictions
None.
Example
To display the syslog source interface:
DGS-3420-28SC:admin#show syslog source_ipif
Command: show syslog source_ipif
Syslog Source IP Interface Configuration:
IP Interface : System
IPv4 Address : None
IPv6 Address : None
DGS-3420-28SC:admin#
63-21 show attack_log
Description
This command is used to display the switch’s attack log.
Format
show attack_log {index <value_list>}
Parameters
index - (Optional) Specify the list of index of the entries that need to be displayed.
<value_list> - Specify the list of index of the entries that need to be displayed. For example, show
attack_log index 1-5 will display the attack log messages from 1 to 5.
Note: If no parameter is specified, all entries in the attack log will be displayed.