D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
747
Format
delete policy_route name <policyroute_name 32>
Parameters
<policyroute_name 32> - The policy route name. The maximum length is 32 characters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP route entry in the Switch’s IP routing table named “duhon”:
DGS-3420-28SC:admin#delete policy_route name duhon
Command: delete policy_route name duhon
Success.
DGS-3420-28SC:admin#
67-3 config policy_route name
Description
This command allows users to configure the different fields for a policy route entry.
Format
config policy_route name <policyroute_name 32> acl profile_id <value 1-6> access_id <value 1-
256> nexthop <ipaddr> state [enable | disable] {route_preference [default | pbr]}
Parameters
<policyroute_name 32> - The policy route name. The maximum length is 32 characters.
acl profile_id - The ACL profile ID.
<value 1-6>- Specifies the value between 1 and 6.
access_id - The ACL access ID.
<value 1-256> - Specifies the value between 1 and 256.
nexthop - The next hop IP address.
<ipaddr> - Specifies the IP address.
state - Activate or deactivate this rule.
enable - Activate this rule.
disable - Deactivate this rule.
route_preference - (Optional) Specifies the priority of this policy route. By default, policy route has
higher priority than routing table, including local, default, static, and dynamic route. The one has
the higher priority should be used to check the traffic first.
default - Specifies that the policy based route has lower priority than the route in the routing table.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English