D-Link xStack DGS-3420 Series - Page 753

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
748
pbr - Specifies that the policy based route has higher priority than the route in the routing table.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure all packets which match ACL rule profile ID=1 and access ID=1, and then route to
20.1.1.100:
DGS-3420-28SC:admin#config policy_route name 1 acl profile_id 1 access_id 1 nexthop
20.1.1.100 state enable route_preference pbr
Command: config policy_route name 1 acl prof
ile_id 1 access_id 1 nexthop 20.1.1.100
state enable route_preference pbr
Success.
DGS-3420-28SC:admin#
67-4 show policy_route
Description
This command is used to display the Switch’s current policy route rules.
Format
show policy_route
Parameters
None.
Restrictions
None.
Example
To display the Switch’s current policy route rules:
DGS-3420-28SC:admin#show policy_route
Command: show policy_route
Policy Routing Table
---------------------
Name Pro- Access Next Hop State Route
file ID Pre-