D-Link xStack DGS-3420 Series - Page 784

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
779
DGS-3420-28SC:admin# config ptp boundary ports all delay_req_interval 0
Command: config ptp boundary ports all delay_req_interval 0
Success.
DGS-3420-28SC:admin#
To configure the pdelay_req_interval attribute of the all PTP ports as 5 seconds:
DGS-3420-28SC:admin# config ptp boundary ports all pdelay_req_interval 5
Command: config ptp boundary ports all pdelay_req_interval 5
The pdelay_req interval is automatically adjusted to 8.
Success.
DGS-3420-28SC:admin#
To configure the delay_mechanism attribute of the all the PTP ports as P2P:
DGS-3420-28SC:admin# config ptp boundary ports all delay_mechanism p2p
Command: config ptp boundary ports all delay_mechanism p2p
Success.
DGS-3420-28SC:admin#
3-3 config ptp p2p_transparent ports
Description
This command is used to configure the pdelay_request message attribute for the message interval of
the P2P transparent clock.
Format
config ptp p2p_transparent ports [<portlist> | all] pdelay_req_interval <sec 1-32>
Parameters
ports - Specifies the list of port used for this configuration.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
pdelay_req_interval - Specifies the permitted mean time interval between successive
messages.
<sec 1-32> - Enter the permitted mean time interval value used here. This value must be
between 1 and 32.