D-Link xStack DGS-3420 Series - Page 87

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
82
Format
config admin local_enable {encrypt [plain_text | sha_1] <password>}
Parameters
encrypt - (Optional) Specifies the encryption type to be used for the password.
plain_text - Specifies that the password entered should be in plain text form.
sha_1 - Specifies that the password entered should be in SHA-1 encrypted form.
<password> - (Optional) Enter the password value used here. Note that for plain_text passwords,
the password can be up to 15 characters long. Note that for SHA-1 encrypted passwords, the
password must be 35 bytes long.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the administrator password:
DGS-3420-28SC:admin#config admin local_enable
Command: config admin local_enable
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-3420-28SC:admin#
To configure the administrator password, specifying an SHA-1 encrypted password of
“*@&cRDtpNCeBiq15KOQsKVyrA0sAiCIZQwq”:
DGS-3420-28SC:admin# config admin local_enable encrypt sha_1
*@&cRDtpNCeBiq15KOQsKVyrA0sAiCIZQwq
Command: config admin local_enable encrypt sha_1
*@&cRDtpNCeBiq15KOQsKVyrA0sAiCIZQwq
Success.
DGS-3420-28SC:admin#
4-29 create aaa server_group
Description
This command is used to create a group of user-defined AAA servers. The maximum number of
supported server groups, including the built-in server groups, is 8. Each group can have a maximum of
8 server hosts.