D-Link xStack DGS-3420 Series - Page 88

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
83
Format
create aaa server_group <string 15>
Parameters
<string 15> - Specify the user-defined server group name.
Restrictions
Only Administrator level can issue this command.
Example
To create a user-defined AAA server group called “mix_1”:
DGS-3420-28SC:admin#create aaa server_group mix_1
Command: create aaa server_group mix_1
Success.
DGS-3420-28SC:admin#
4-30 config aaa server_group
Description
This command is used to add or remove an AAA server host to or from the specified server group. The
built-in TACACS, XTACACS, TACACS+, and RADIUS server groups only accept server hosts with the
same protocol, but a user-defined server group can accept server hosts with different protocols.
Format
config aaa server_group [tacacs | xtacacs | tacacs+ | radius | group_name <string 15>] [add |
delete] server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
tacacs - Specify the built-in TACACS server group.
xtacacs - Specify the built-in XTACACS server group.
tacacs+ - Specify the built-in TACACS+ server group.
radius - Specify the built-in RADIUS server group.
group_name - Specify a user-defined server group.
<string 15> - Enter the name of the server group.
add - Add a server host to the server group.
delete - Remove a server host to the server group.
server_host - Specify the server host.
<ipaddr> - Enter the IP address of the server host.