D-Link xStack DGS-3420 Series - Page 898

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
893
Restrictions
None.
Example
To display the recipient for which the traps are targeted:
DGS-3420-28SC:admin# show snmp v6host
Command: show snmp v6host
SNMP Host Table
-------------------------------------------------------------------
Host IPv6 Address: FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
SNMP Version : V3 na/np
Community Name/SNMPv3 User Name: 123456789101234567890
Host IPv6 Address: FECO:1A49:2AA:FF:FE34:CA8F
SNMP Version : V3 a/np
Community Name/SNMPv3 User Name: abcdefghijk
Total Entries : 2
DGS-3420-28SC:admin#
15-20 enable community_encryption
Description
This command is used to enable the encryption state on the SNMP community string.
Format
enable community_encryption
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the encryption state on an SNMP community string: