D-Link xStack DGS-3420 Series - Page 899

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
894
DGS-3420-28SC:admin# enable community_encryption
Command: enable community_encryption
Success.
DGS-3420-28SC:admin#
When creating an SNMP community string after the encryption state has been enabled, the
community string will be displayed as an encrypted string (six "*"), otherwise displayed as plaintext, for
example:
DGS-3420-28SC:admin# show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
--------------------- --------------------- ------------
****** CommunityView read_write
****** CommunityView read_only
private CommunityView read_write
public CommunityView read_only
Total Entries : 4
DGS-3420-28SC:admin#
15-21 disable community_encryption
Description
This command is used to disable the encryption state on the SNMP community string.
Format
disable community_encryption
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To disable the encryption state on the SNMP community string: