xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
934
DGS-3420-28SC:admin# show stack_device
Command: show stack_device
Box ID Box Type H/W Version Serial Number
------- --------------- ------------ ----------------
1 DGS-3420-28SC B1 D1234567890
2 DGS-3420-28SC B1 D1234567891
19-6 config box_id current_box_id
Description
This command configures the box ID. By default, the box ID is automatically assigned by the system
based topology election results. Administrators can assign box IDs statically. The new box ID will take
effect after unit reboot. Each unit in the Switch stack must have a unique box IDs. If the IDs duplicate,
the stack system cannot stack normally.
Format
config box_id current_box_id <value 1-12> new_box_id [auto | <value 1-12>]
Parameters
<value 1-12> - Enter the current box ID value used here. This value must be between 1 and 12.
new_box_id - Specifies the new ID assigned to the box.
auto - Specifies that the box ID to be assigned automatically by the stack system. The new
box ID will take effect after the next boot.
<value 1-12> - Enter the new box ID used here. This value must be between 1 and 12.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure box ID of box 1 to be auto:
DGS-3420-28SC:admin# config box_id current_box_id 1 new_box_id auto
Command: config box_id current_box_id 1 new_box_id auto
Success.
To Next Page
Loading...
Need help?
General