xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
935
19-7 config box_priority current_box_id
Description
This command configures the priority of switch, which will determines which box becomes master.
Lower number means higher priority. New priority will take effect after user reboot
Format
config box_priority current_box_id <value 1-12> priority <value 1-63>
Parameters
<value 1-12> - Enter the current box ID value used here. This value must be between 1 and 12.
priority - Specifies the priority assigned to the box, with lower number meaning higher priority.
<value 1-63> - Enter the priority value used here. This value must be between 1 and 63.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure box priority:
DGS-3420-28SC:admin# config box_priority current_box_id 1 priority 1
Command: config box_priority current_box_id 1 priority 1
Success.
19-8 config stacking log state
Description
This command is used to configure the log state for stacking.
Format
config stacking log state [enable | disable]
Parameters
enable - Specifies that the Switch’s stacking log will be enabled.
disable - Specifies that the Switch’s stacking log will be disabled.
To Next Page
Loading...
Need help?
General