xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
936
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the stacking log state:
DGS-3420-28SC:admin#config stacking log state enable
Command: config stacking log state enable
Success.
19-9 config stacking trap state
Description
This command is used to configure the trap state for stacking.
Format
config stacking trap state [enable | disable]
Parameters
enable - Specifies that the Switch’s stacking trap will be enabled.
disable - Specifies that the Switch’s stacking trap will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the stacking trap state:
DGS-3420-28SC:admin# config stacking trap state enable
Command: config stacking trap state enable
Success.
To Next Page
Loading...
