doble TDR9000 - Page 11

72A-1898 Rev. A 11/01 vii
Monday, November 26, 2001 1:09 pm
Figures
Figure 1.1 Step 1: Circuit Breaker Control Cabinet Preparation...................................... 1-4
Figure 1.2 Step 2: Physical Front Panel for EHV Test ..................................................... 1-7
Figure 1.3 Step 2: Physical Front Panel for OCB/Motion Test......................................... 1-7
Figure 1.4 Step 2: Physical Front Panel for Trigger In Test.............................................. 1-8
Figure 1.5 Step 2: Physical Front Panel for Auxiliary Input Trigger Test.......................... 1-8
Figure 1.6 Step 3: Dead Tank Test Setup ..................................................................... 1-12
Figure 1.7 Step 3: Live Tank Test Setup ....................................................................... 1-12
Figure 1.8 Installation with Circuit Breaker Contact Monitor Cabling .......................... 1-13
Figure 1.9 Step 3: Rotary Motion (Transducer with Rotary Adapter)............................. 1-14
Figure 1.10 Step 3: Linear Motion (Transducer with Rod) .............................................. 1-14
Figure 1.11 Step 4: TDR9000
™
and PC Wiring.............................................................. 1-16
Figure 1.12 Step 4: TRXField
™
Test Plan (Partial)........................................................... 1-17
Figure 1.13 Step 4: Virtual Front Panel .......................................................................... 1-18
Figure 1.14 Breaker with Safety Grounds Removed ....................................................... 1-19
Figure 1.15 Continuity Test ........................................................................................... 1-20
Figure 1.16 Continuity Test Results................................................................................ 1-21
Figure 1.17 Run Test ..................................................................................................... 1-21
Figure 1.18 Saving Test Results...................................................................................... 1-22
Figure 2.1 TDR9000
™
Circuit Breaker Test System........................................................ 2-1
Figure 2.2 TDR9000
™
System Topology........................................................................ 2-3
Figure 2.3 TDR9000
™
System Information Flow Diagram ............................................. 2-4
Figure 2.4 OCB/Motion Module Configurations ............................................................ 2-6
Figure 2.5 EHV Module Configuration........................................................................... 2-7
Figure 2.6 Event Module Configurations........................................................................ 2-8
Figure 2.7 System Module Configurations ..................................................................... 2-9
Figure 2.8 Trip Command Pulse .................................................................................. 2-13
Figure 2.9 Close Command Pulse................................................................................ 2-14
Figure 2.10 Reclose Command Pulse ............................................................................ 2-15
Figure 2.11 Trip Free Command Pulse........................................................................... 2-16
Figure 2.12 O-C-O Command Pulse.............................................................................. 2-17
Figure 3.1 TDR9000
™
Physical Front Panel Connections .............................................. 3-2
Figure 3.2 TDR9000
™
Virtual Front Panel ..................................................................... 3-4
Figure 3.3 Navigating Tabs I.......................................................................................... 3-5
Figure 3.4 Navigating Tabs II......................................................................................... 3-5